Nothing on the walls. Heat only the rooms you use. Slim white PowerBoard panels on the ceiling warm people and everything in the room directly, instead of heating the air first. Supplied and installed across the UK.
Carbon fibre heating film converts virtually all electricity directly into radiant heat - there's no heat lost up a flue or through pipework
Reaches full operating temperature in around 10 minutes - no boiler warm-up time, no early morning pre-heat scheduling
Ceiling mount using our plug-and-play cable system - the mechanical fix is a straightforward job, electrical connection by a Part P electrician
No moving parts, no boiler checks, no annual service required - just silent, reliable heat year after year
Multiple panels spaced evenly across the ceiling mean uniform warmth in every corner of the room - no cold spots, no hot blasts
The only PowerBoard panel that can be recessed flush into your ceiling - once plastered and painted, it disappears completely
Inside the panel
The PowerBoard-S 250W is 1200 by 600mm and 12.5mm thin, the same build depth as a sheet of plasterboard. Here is what is between the room and the ceiling void.
Full surface radiant warmth · 99.7% of the electricity becomes heat · Must be installed by a qualified electrician in accordance with BS 7671
Four parts, one circuit. Pre-made leads click into the sealed four-way adapter, so your electrician wires the room, not every panel.
The heating is one part of an all-electric home. Everything here is designed to run together, and we supply and specify all of it.
Run the heating on your own generation and cut the running cost to the export rate you gave up.
Room-by-room schedules, presence detection and one app for the whole house.
Divert surplus solar into the cylinder and heat water off-peak, alongside the panels.
Side-by-side against the most common electric heating types people switch from.
Swipe the table sideways to compare all five heating types.
Steps shown for Surface mount, change mount selection above to see integrated steps.
Mark ceiling joist positions and plan your cable route to the thermostat location.
Screw the 20mm surface mount spacer to the joist, fixings supplied by your installer. The cable entry is fixed in the panel, so the spacer position determines your cable routing depth.
Connect the plug-and-play cable harness to the panel connector, no hardwiring at the panel. Run the supply cable to the thermostat.
Connect the circuit at the thermostat (Part P certified electrician). Set temperature, verify operation, and you're done.
PowerBoard-S panel ceiling installation, plug-and-play harness system
The question that actually matters with electric heating.
13p
A day to run this panel, in typical zoned use
£3.90
A month across the heating season
£47
A year, spread over the full heating schedule
Based on about 5 heating hours a day with panels actually drawing power roughly 38% of that time, because thermostats cycle panels off once a room is at temperature and unoccupied rooms are not heated, at 27p/kWh. We keep this rate fixed, set just above Ofgem's price cap when we chose it (26.32p, October 2026).
Frequently ordered alongside this product
Heat a bedroom or study in 10 minutes - surface mount, fewer panels, no boiler
Heat your living room or kitchen in 10 minutes - fewer panels, less wiring, no boiler
Two BEAB Approved panels boarded flush into the bathroom ceiling, warm in under 10 minutes